
Wet Films
- Fixer is depleted.
- Hardener was left out of fixer.
- Developer or fixer is under-replenished.
- Developer level in the processor is low.
- Developer in the processor has been contaminated by fixer or water.
- Developer or fixer has been mixed with too much water, or not the correct amount of
hardener.
- Developer temperature is too low and or fixer temperature is too high.
- Recirculation in the processor may have stopped.
- Dryer temperature may be too low.
- Reduced water flow in the processor, check supply and drain for blockage.
Go Back